Instruction ManualFlange Mounting Kit
2(3x)(3x)1 Prepare the panel opening per the diagram on page 6.2 Install the Front Flange using three (3) 10-32 x 7/8" Socket Pan Head Screws a
34 Install one (1) additional 10-32 Nut onto each screw. Hand-tighten only.Detail, showing the two (2) 10-32 Nuts mounted on the 10-32 x 7/8" So
4(3x)5 From the back side, install the Rear Port XP2i.6 Install the Rear Flange over the XP2i using three (3) 10-32 Nuts. Tighten using a 3/8"
57 Back out each of the three (3) hand-tight nuts installed in step 3, until they t snugly against the Rear ange.8 Using a 3/8" wrench, tight
6Mounting Bolt Circle5.38" (136.7mm) ØPanel Opening4.94" (125.5mm) ØØ Mounting Bolt Hole0.22" (5.6mm) 120˚120˚120˚Flange Mounting Dia
7QTY 1QTY 3 QTY 10 QTY 2 10-32 x 7/8" Socket Pan Head ScrewsHex Key10-32 Nuts Flanges incluDeD Parts
3962.E© 2013 Crystal Engineering Corporation708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701
Commentaires sur ces manuels