Crystal FastCalXP Calibration Software Manuel d'utilisateur télécharger pdf (Page 15)

Calibrating Gauges  13

FastCalXP Operation Manual

If the new gauge is a transmitter and Measure HART was selected, the New Gauge Wizard will display a HART Information dialog box.

The Manufacturer ID, the Device type ID and the Device ID combined together form the unique ID, de ned by the manufacturer, that is used to communi-

cate with a smart transmitter during the calibration session. This ID can be entered manually by consulting the transmitter documentation or determined

automatically by FastCalXP.

12 If the smart transmitter is powered on and connected to a HART modem which is connected to one of the computer’s serial ports, click on the Discover…

button

to automatically poll the default com port for HART information.

13 If the HART modem is not connected to the default COM port, click Stop. Select the correct COM port from the pull-down list and press the Start button.

The HART Modem will poll the network for any devices connected and display the results. Select the desired HART device from the list and press the

OK button to enter the ID of the desired transmitter.

14 Click the Finish button to store the new gauge and close the New Gauge Wizard.

When the New Gauge Wizard has been completed FastCalXP will automatically load the new gauge.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 58 59

Commentaires sur ces manuels

Pas de commentaire

Crystal FastCalXP Calibration Software Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Crystal FastCalXP Calibration Software