Crystal FastCalXP Calibration Software Manuel d'utilisateur télécharger pdf (Page 30)

Settings and Options  28

FastCalXP Operation Manual



Save Certi cates To

The calibration certi cates created by FastCalXP will be saved in the directory speci ed in Save certi cates to. This directory is set the  rst time the software is

run after installation or when a new database is created and can be changed here using the Browse button.



Certi cate Naming Template

The Certi cate naming template is used by FastCalXP to name the calibration certi cates. In general, certi cates are numbered with the Next certi cate

number incrementing automatically each time a certi cat

e is created. Use number signs (#’s) in the Certi cate naming template to de ne the number of digits

to be used.



Calibration Representative and Quality Representative

The Calibration representative and the Quality representative must be listed users and can be selected using the pull-down lists. In the certi cate template

provided with the software these names will be listed, with signature lines, on the  rst page of each certi cate.

Calibration Settings

The Calibration Settings de ne the default Calibration Method.



Actual

Uses the pressure reading from the reference at the moment the Next Point button is clicked.



Peak

Automatically advances to the Next Point when a peak is detected.



Head Correction

If the gauge and the reference do not sit at the same height, a Head correction can be applied. Enter a correction to be added to the reference pressure, or use

the Correction calculator to calculate a correction given the speci c conditions of the calibration. Refer to the discussion of the Head Correction Calculator

on page 32.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 58 59

Commentaires sur ces manuels

Pas de commentaire

Crystal FastCalXP Calibration Software Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Crystal FastCalXP Calibration Software